Shelby Posted April 23, 2008 Report Share Posted April 23, 2008 spoon fulls the dish on the piston can hold 3 or 4 ounces and not get oil any where else esp on the walls ,you ay be ok if it spit oil back out when you spun the engine ,, you did spin it with no plugs right Link to comment Share on other sites More sharing options...
shift1313 Posted April 23, 2008 Report Share Posted April 23, 2008 (edited) http://s268.photobucket.com/albums/jj39/sh...austInside2.flv http://s268.photobucket.com/albums/jj39/sh...nt=PA140032.flv dont mind the smoke in the second one:) edit. 2.5" from turbo back, no cats, dynomax bullet muffler. Edited April 23, 2008 by shift1313 Link to comment Share on other sites More sharing options...
jd_stazza_brendan Posted April 23, 2008 Report Share Posted April 23, 2008 (edited) Old video where i stand to close to the exhaust i think. Ill make another one this weekend. 3 inch turbo back with cat and rear muffler on a 2L SOHC From 2:05 onwards.. Yea i got noisey tappets... new motor soon, cant be bothered adjusting them. Edited April 23, 2008 by jd_stazza_brendan Link to comment Share on other sites More sharing options...
heefner Posted April 24, 2008 Report Share Posted April 24, 2008 Engine was cold so it was hesitant to rev quickly that also explains the black smoke runs a little on the rich side on cold start up. Its a little loud to drive with company and it always pisses off the people next to you in traffic on cell phones. http://videos.streetfire.net/video/quest-w...aust_158500.htm Link to comment Share on other sites More sharing options...
pure_insanity Posted April 24, 2008 Report Share Posted April 24, 2008 spoon fulls the dish on the piston can hold 3 or 4 ounces and not get oil any where else esp on the walls ,you ay be ok if it spit oil back out when you spun the engine ,, you did spin it with no plugs right shelby, im a southerner. a couple spoonfulls doesnt mean i measured it out with spoons. that means i poured some in till i felt like i had enough in there. in all actuality i prolly put about half a cup in there that i poured down the cylinder against the cyl wall as best i could. then i bumped the starter to make it move up and down to coat the cyl. wall. either way, i feel like i got plenty of oil in there. ive had a few cases of this over the years and this is the same method ive always used and never had a problem. Link to comment Share on other sites More sharing options...
Shelby Posted April 24, 2008 Report Share Posted April 24, 2008 hey thats fine, we can't always tell the level of expertize of the poster and it's better to waste a few lines of internet space then alow some one to fail to get enought oil in the cyls and have them rust , many people have no idea of just how fast a cyl wall will rust if air or coolant is left in them , and come back a couple months later to a loc'd up engine Link to comment Share on other sites More sharing options...
88conquest_nutz Posted April 25, 2008 Report Share Posted April 25, 2008 does it have to be a SQ? heres my little old cavalier http://videos.streetfire.net/video/cavalie...ecial_48287.htm yea yea its only a cavalier :party0009: http://media.putfile.com/660-True-Duals Link to comment Share on other sites More sharing options...
jd_stazza_brendan Posted April 25, 2008 Report Share Posted April 25, 2008 New Vid Link to comment Share on other sites More sharing options...
randomguy Posted April 25, 2008 Report Share Posted April 25, 2008 sickly car 3 inch turbo back behind a turbonetics 60-1.. (You cant tell from the video but you can hear the turbo at idle thru the exhaust) http://www.youtube.com/watch?v=ONuXWYsKrtM another angle: Link to comment Share on other sites More sharing options...
Fanta Posted April 26, 2008 Author Report Share Posted April 26, 2008 seriously, you guys have no idea how wicked randomguy's exhaust sounds like. Last night I was assisting him in getting his FPR in line so it could start up. It's like a Harley meets a cammed v8 meets a WW2 Pratt & Whitney V10 Link to comment Share on other sites More sharing options...
shift1313 Posted April 26, 2008 Report Share Posted April 26, 2008 i took a few vids while driving home the other night. Nothing spectacular but the normal exhaust note. http://s268.photobucket.com/albums/jj39/sh...secondaccel.flv the first vid is just crusing in 2nd and starting to accel. the second is cruising in 4th gear around 1500-2000k http://s268.photobucket.com/albums/jj39/sh...ent=harding.flv Link to comment Share on other sites More sharing options...
Couth'nize Posted April 26, 2008 Report Share Posted April 26, 2008 (edited) Found my old '86 video...Try to get your car to sound like this... Edited April 26, 2008 by Couth'nize Link to comment Share on other sites More sharing options...
Shelby Posted April 26, 2008 Report Share Posted April 26, 2008 these newer cam corders may take better pics then the older ones but the sound is no where near as good as the older ones Link to comment Share on other sites More sharing options...
shift1313 Posted April 26, 2008 Report Share Posted April 26, 2008 mine was just a digi camera that takes video. im sure it would have been much nicer with an actual video camera Link to comment Share on other sites More sharing options...
chiplee Posted April 27, 2008 Report Share Posted April 27, 2008 guess I forgot to make a real entry. http://s212.photobucket.com/albums/cc82/ch...nt=DSCN1534.flv Link to comment Share on other sites More sharing options...
thagremlin Posted April 27, 2008 Report Share Posted April 27, 2008 heres mine kinda old.. almost a year ago.. http://s46.photobucket.com/albums/f125/tha...=Picture151.flv Link to comment Share on other sites More sharing options...
yoshi Posted April 27, 2008 Report Share Posted April 27, 2008 (edited) i took a few vids while driving home the other night. Nothing spectacular but the normal exhaust note. http://s268.photobucket.com/albums/jj39/sh...secondaccel.flv the first vid is just crusing in 2nd and starting to accel. the second is cruising in 4th gear around 1500-2000k http://s268.photobucket.com/albums/jj39/sh...ent=harding.flv I like the sound of your exhaust.shift1313..hope mine can sound like that...once I get it working...lol Edited April 27, 2008 by yoshi Link to comment Share on other sites More sharing options...
Zack_Morris Posted April 27, 2008 Report Share Posted April 27, 2008 end of the week i should have my entry Link to comment Share on other sites More sharing options...
Pr4mnceMan Posted April 28, 2008 Report Share Posted April 28, 2008 Link to comment Share on other sites More sharing options...
FijiPhil Posted April 28, 2008 Report Share Posted April 28, 2008 Couth, your 86 sounds pretty awesome, but i think i like Rondomguys second angle better Link to comment Share on other sites More sharing options...
Pr4mnceMan Posted April 28, 2008 Report Share Posted April 28, 2008 Heres my starion: Link to comment Share on other sites More sharing options...
scott87star Posted May 2, 2008 Report Share Posted May 2, 2008 3" turbo back with cat and 3" flowmaster. Scott Link to comment Share on other sites More sharing options...
Elkidmino Posted May 5, 2008 Report Share Posted May 5, 2008 Car as of Friday when I left school: http://www.facebook.com/video/video.php?v=12233994356 Link to comment Share on other sites More sharing options...
BOOSTED88tsi Posted May 5, 2008 Report Share Posted May 5, 2008 Car as of Friday when I left school: http://www.facebook.com/video/video.php?v=12233994356 No worky... got to be a member Link to comment Share on other sites More sharing options...
acidbath Posted May 5, 2008 Report Share Posted May 5, 2008 All you guys make my car sound like a tractor! hahah I'll upload a video soon as my camera charges. Link to comment Share on other sites More sharing options...
Recommended Posts