Jump to content



techboy

Member Since 29 Jun 2009
Offline Last Active Today, 10:40 AM
*****

Posts I've Made

In Topic: To use sta-bil or not to use?

Today, 10:34 AM

I use Sta-bil in my lawn mowers and stuff, but I never have used it in a car.  If I knew I were storing it long term, I would probably do like the post above and run it down low, and then drain it from the plug in the bottom of the tank.

In Topic: FS: (MA, USA) G54B Block w/ Timing Cover & Crank $30

Today, 10:31 AM

That's a steal for 30 bucks!

In Topic: Shaved Gas Lid (WHITE)---No keyhole

13 September 2018 - 10:27 AM

View PostBradrock, on 13 September 2018 - 10:24 AM, said:

Is that a welded patch? Or did they fill over a piece of tape?

Hard to tell.

I'm thinking maybe for the tab a piece of bent metal and some epoxy?

There was someone on this board a few years ago that had one of these on his car, I always thought it was cool.

In Topic: Throttle body spacer?? Any interest??

09 September 2018 - 08:21 PM

How thick is the plate?  And does it work with people that are already aftermarket injectors that have spaces?  I know for me, and most other guys things are pretty tight against the hood already.

Also, how does it effect, if it all, the coolant passages that run through the TB?

EDIT: I'm interested.

In Topic: Tig/Mig table labor day special cheap!

02 September 2018 - 12:59 PM

On college I used to have a prof who always would say "heat it, beat it, and paint it black". Just need the black now.