Jump to content

Throw me a rough estimate


kryo_strife189
 Share

Recommended Posts

Stock weight minus the whole rear hatch and passenger window are gone...

 

Engine:

complete balance shaft removal

clevite 77 rod and mains

race prepped rod and crank

arp hardware

fidanza flywheel

xtd stage 3 clutch kit (6 puck)

8.5mm wires

ngk 9 iridium plugs

msd blaster 2 coil

 

turbo is running 24 psi

intercooled

k&n air filter

6 injector TBI

marnal aftermaket head (port and polish)

ARP head bolts

racing composite head gasket

 

This is what i have done at the moment and was wanting some guesstimates at numbers?

 

What i have planned: (complete project) ((Needs to be revised i know i have some useless things don't criticize me just yet lmao and no name brands listed yet))

 

Intake:

35-45 psi turbocharger w/ RFL BOV

Custom Ram air ducts

3 psi electric supercharger

Racing Air Filter

Water methanol injected intercooler

OR-----------------------------OR

Nos intercooler Spray bar

10 psi Belt driven supercharger

Custom MPI setup (6 injectors)

High cc injectors

250-500 NOS shot direct port (HIDDEN)

Port and polised with 3 angle on intake manifold

Fuel System:

High Flow fuel pump

High flow steel braided lines

High flow Fuel filter

 

Engine:

Top:

Stainless Steel Oversized Valves

Custom turbo cam

Aftermarket cylinder head (ported and polished with 3 angle)

Arp Head studs

Racing composite head gasket

Bottom:

Forged con rods

Forged pistons (overbore and 8:1 or lower compression)

Molly rings

Forged crankshaft with knife edge and balance

ARP rod and main bolts

Clevitte 77 rod and main bearings

Balance shaft complete removal

High pressure oil pump and water pump

Racing Flywheel

Racing Oil filter

 

Drive train:

T56 6 speed tranny

stage 3 clutch kit (6 puck)

upgrade the LSD

change out the gear ratio

 

Ignition:

NGK IX Iridium plugs

High amp battery cell

8.5mm cables

Distributor (digital or points???)

High output ignition coil

Ignition Amplifier

2 stage rpm limiter

high amp alternator

 

Exhaust:

Custom Turbo manifold (for Turbo) with heat wrap

Custom downpipe for Turbo

2.5 racing exhaust (no fart cannons!!!)

Custom end pipes

 

Suspension:

Tokico & Kyb coilovers

OR--------------OR

MKI full coil over kit

Oversteer (60 to 80 degree turn)

 

Brakes:

Steel Braided Lines

6 piston calipers w/ racing composite pads

Slotted and drilled rotors (oversized???)

ABS system upgraded or removed

 

Cooling:

Custom 3 row aluminum radiator

Dual or single HIGH rpm radiator fans

Steering fluid cooler

Fuel cooler

Oil cooler

 

Body:

Carbon Fiber Hood (83 style with hood scoop)

Carbon fiber quarter panels

Custom door lifts

black paint (unsure of style or type)

Blue underglow

Halo blue headlights

chrome tinted windows, black tinted, or blue tinted

Powder coated 2 tone original alloy rims (black on chrome)

Z rated race tires

Blue LED rearview mirrors

Hide away plate (lmao)

Rear light assembly switch

Custom nos blow off valves

Interior:

Restored black leather interior

Custom gauge cluster (blue LED)

Custom audio and video setup

Built in dash laptop for diagnostics and media management

LIDAR jammer 360 degrees

Radar detector 360 degrees

Blue LED lighting setup

 

HP and TQ guesstimates????

Edited by kryo_strife189
Link to comment
Share on other sites

What turbo are you running 24 psi on?

 

unsure at the moment... when i bought the car the guy claimed it was a 20g but i don't think it is... haven't really looked at it since i've been doing all the engine work...

 

i do also know i have a 1g mas as well

 

and i said there was some useless overkill stuff on there

Link to comment
Share on other sites

HP is going to be in the tune and the led's and electric supercharger...........

 

Now why in the world would you consider an electric supercharger?

 

Custom door lifts?

 

Carbon fiber quarters?

 

I understand wanting to mod a car, maybe I'm getting old but don't you think it's overkill? I would just construct the car out of unobtanium, since your in roswell you might be able to find some from the crash.

 

Realistically. 500hp would be a safe guess but I would not call it reliable..... What do you want to use the car for?

 

 

Link to comment
Share on other sites

lol i've learned that if i set my goals extremely high i know i won't get it all but still ongoing

 

believe me i know that i won't get all that but it's nice to dream

 

u ask me what i want to use the car for and honestly i couldn't give you an answer... but i like the starquests alot and since i already have a few other vehicles it would be a show car with the balls to back it up... even though chrome don't get you home lol

 

the electric supercharger on that list was an old joke that i still like to remember and why not LED'S they are cheap and easy to come by

 

I never said i was gonna obtain everything on that list it's just a list it doesn't need to be looked down upon i could be talking about a honda with a b16 a cold air intake and a fart cannon saying it's the fastest on the street! lol

 

there is always worse stuff to criticize

Edited by kryo_strife189
Link to comment
Share on other sites

i know that... i bought it like that... the passenger window and rear hatch were both shot out... previous owner had gotten into some stuff he shouldn't have... so he sold me this car running title and all for 200 bucks... i wasn't gonna pass that up
Link to comment
Share on other sites

You dont know what turbo you are running with 24 psi which is already out of reach of most people on this site. You have a 6 injector TB setup going? I want pics.

 

Do you have a wideband so you know your not blowing s*** up?

 

Do you have forged pistons because i bet this thing blows before it ever runs :D

Link to comment
Share on other sites

why not add a couple spoonfuls of real world to your coffee and take another look at that list and then start over

 

this is a 4 cyl,, a 300hp shot of nox and the engine will gernade on the spot :biggrinumbrella1:

Link to comment
Share on other sites

why not add a couple spoonfuls of real world to your coffee and take another look at that list and then start over

 

this is a 4 cyl,, a 300hp shot of nox and the engine will gernade on the spot :biggrinumbrella1:

 

 

it will make one hell of a first impression, and a lasting inpression all at once.. :hmm3grin2orange:

Link to comment
Share on other sites

Engine:

intercooled

racing composite head gasket

Custom Ram Air ducts

3 psi electric supercharger

Racing Air Filter

10 psi Belt driven supercharger

Custom MPI setup (6 injectors)

High cc injectors

250-500 NOS shot direct port (HIDDEN)

Port and polised with 3 angle on intake manifold

Engine:

Top:

Aftermarket cylinder head (ported and polished with 3 angle)

Racing composite head gasket

 

Bottom:

Forged crankshaft with knife edge and balance

High pressure oil pump and water pump

Racing Flywheel

Racing Oil filter

 

Drive train:

upgrade the LSD

 

Ignition:

Distributor (digital or points???)

 

Suspension:

Tokico & Kyb coilovers

Oversteer (60 to 80 degree turn)

 

Brakes:

6 piston calipers w/ racing composite pads

Slotted and drilled rotors (oversized???)

ABS system upgraded or removal

 

Body:

Carbon fiber quarter panels

Custom door lifts

Blue underglow

Halo blue headlights

chrome tinted windows, black tinted, or blue tinted

Blue LED rearview mirrors

Hide away plate (lmao)

Custom nos blow off valves

Interior:

Blue LED lighting setup

 

 

 

Everything I have left in your list is what I have issues with. These are not your moms Honda. A 250 shot of nitrous or N2O (not NOS unless its actually the NOS brand) will send your head into orbit and your rods to China. Why would you supercharge it? That's going to create a huge bottleneck for the turbo at "35-45" psi as you have listed. Why 6 injectors? Why not 8? Why not just 4 95lb per hour injectors? Ported and polished manifold is cool, but 3 angle? 3 angle on what? That's a valve job term. You don't put a 3 angle on everything.

 

Your forged crank and high pressure oil pump not in existence. The stock cranks are quite strong as they are hardened from the factory. By eliminating your balance shafts, your oil pressure will increase.

 

Upgrade the LSD to what?

 

Points distributor? Try again bud.

 

Tokico and KYB are discontinued for the most part and getting harder to find by the day.

 

Oversteer? Where are you finding these things?

 

That an entirely custom brake system you're talking about. The ABS is not upgradeable.

 

Carbon fiber quarters: good luck

 

All the blue you are planning to put on/in the car will get you in serious trouble with the Police.

 

I'm assuming your "custom nos blow-off valves" are purge valves for nitrous.

 

Please do some research on parts available and on the car itself before throwing out a list like this.

 

 

 

 

 

 

And for my estimate: 600whp. Once.

Link to comment
Share on other sites

  • 1 month later...
you guys are taking the Total list too far into reallity. I never said i was gonna achieve it and i know its not a real world situation it was just a list that i had made up a while back for fun. it's a useless list kinda meant to get picked at lol. i don't actually plan on acheiving all that and i'll try and get pics when i can on that 6 injector setup. it's the stock tbi with 4 more injectors mounted like a mpi but only use the 4 injectors when it actually starts boosting. again you guys take this list to seriously. It's just a plain bs list! its just for fun honestly there is no intention behind it
Link to comment
Share on other sites

 Share

×
×
  • Create New...