Jump to content

    Removing the pitman arm and idler arm from the center link.

    varzaman
    By varzaman,
    I have a ball joint separator with a 3/4" opening from Harbor Freight, like so: https://www.harborfreight.com/3-4-quarter-inch-forged-ball-joint-separator-99849.html   I was hoping this would be a good replacement for the tool the manual lists as MB991113/MB990635. Unfortunately it doesn't actually fit, the jaws are too narrow for me to get underneath the idler or pitman arm.      I can't find any specs about the MB991113/MB990635, so I have no idea how big their jaw openin

    Grommets for fenders

    tux
    By tux,
    Does anyone know of a good solution to replace the grommets in the channels above the fenders (that ones that the factory wiring runs through)?

    V66 Promo

    Contsi
    By Contsi,
    https://streamable.com/w7dwcq

    Dads got a website do over!

    Dad
    By Dad,
    Hey Guys and Gals, check out our new website    Dads Engine Parts Dad

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...