Had some parts left over. a)Door panel trim cllips (2) Mb223933,(6)Mb37427,(4)Mb189910 shipped $9 PENDING b)Damper Tensioner and rubber sheets Md084945, Md021242 $11 shipped c)Lower shores rebuilt tb $40 shipped d)good tps $15 shipped PENDING e)Injector only gaskets Md61410 $5 shipped f)"Dads" timing chain kits new in box.$39shipped g)Dads balance chain kit new in box $42 shipped h)Complete service manuals for '88 starion $40 shipped PENDING i)Nice driver side corner reflector 'red' $10 shipped

i have 4 of these. bought them from rs-autosport   they do not have pigtails, so you would need to crimp and solder them to the connector.   asking 25 shipped for them   http://www.rs-autosport.net/catalog/produc...products_id=189

Hello All   Here is a partial list of some miscellaneous parts that I wont be using and hopefully they will be of use to someone. I have listed whether the part is new or used to the best of my knowledge. If I had any doubt I listed it as used. I am a bit flexible on the prices and may even be up for some trading so let me know, but please be reasonable. I dont "have" to sell this stuff and I will hold on to it rather than "give" it away.   All parts are located just southwest of Cleveland. I d

IMPORTANT NOTE: Do NOT burn tables ('Calibrate AFR Table' or 'Calibrate Thermistor Tables') on a running engine. Even idle is NOT allowed, because these tables ONLY exist in flash, so once a table is erased, there is nothing but garbage in there until it is re-programmed, one word at a time. Until that reprogramming is complete, operating the engine is unsafe.   Ok, I did that: calibrated thermistors with engine running. MSII, V3, variant 028. So how do I do this reprogramming? BTW, the thermis