Jump to content

  • Welcome (back) to StarQuestClub!

    OH NO!!!

    The data center where the site was housed on a Virtual Machine was shut down. The person who was in charge of the VM never saw the emails about migrating because it was flagged as spam and went to his junk folder. Long story short, they turned off the lights and locked the door without SQC being migrated to a new server.


    Unfortunately the most viable backup to use is from Nov. 2015 so we lost numerous posts and registered members. If you joined after that date you will need to register again.


    The new site requires you to use the email address in your profile to log into SQC and whatever password you had back in 2015. If you don’t remember your password there is a “Forgot your password?” option at the bottom of the Sign In block. If you don’t remember the email you used in your profile contact one of the Moderators for assistance or email loginhelp@starquestclub.com 

    Pictures?

    SQF
    By SQF,
    Is there (or will there be) a way to drop pics into posts like on the other site?   Just curious. URL's also.

    Setting the Timing

    BuzzKill
    By BuzzKill,
    Take off the valve cover so you can see the valve train. With a big socket wrench, turn the crankshaft pully bolt (clockwise only!!!) until the timing mark on the pully is right at the 0 degree timing mark. Look at your camshaft sprocket -see the pin that locks it to the small stub that sticks forward to drive the distributor? That pin should be right at 12 o'clock - straight up. If it's near 6 o'clock, turn your crankshaft one full turn (clockwise again!) back to 0 deg. Now that pin should be

    Rear Hatch Adjustment/Rear Wiper/Center brake fix

    BuzzKill
    By BuzzKill,
    The hinges on the rear lid are adjustable on the body, here is how you do it (It is a pain in the a**).   NOTE: It is very helpful to have a factory manual anytime attempting a task of this nature. The manual illustrates how to remove such panels without damaging them.   1. Remove the rear headliner (roll bar trim) by prying downward on the rear of the liner (edge near the hatch opening) and inserting a trim stick or screw driver between the liner and the clips. Remove the clips and remove the

    Injector Clip Replacement/Wire Colors

    BuzzKill
    By BuzzKill,
    The injector clips often get corroded/gunked up and fail to make a proper contact. The primary injector runs until around 3000 RPM (about the same time you reach 0 psi on the boost gauge) and then the secondary kicks in. If the secondary injector doesn't start spraying, the car suddenly goes into a major lean-out and falls on its face.   Go out and buy some new injector clips (sometimes also called "connectors", "sockets" or "pigtails"). They're found at most parts stores for $5-10 each, usuall

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...