Hi everyone,   I am after enough washers to re-build 2 sets of rear calipers. The actual part I am after is what's called a "belleville" washer, it is part of the hand-brake (e-brake) system in the rear caliper. When stacked over each other they work as spring. Someone at MMC was most likely smoking meth when they designed the rear calipers for this car because it is weird, painfully complex and disintegrates into dust with a little moisture exposure. The Mitsubishi part number is

ISO: A/C vacuum hose that goes from compressor low pressure / vacuum side toward evaporator  

I'm finally getting car ready to go! https://www.instagram.com/reel/Cb5q6jHAH7n/?igshid=YmMyMTA2M2Y=

1983 Mitsubishi Starion Still trying to work through various electrical gremlins and can't seem to get spark. Air, fuel, and compression is all good. Just replaced the ignition coil and still nothing. Fusible links for Ignition Switch and ECI are good. Pickup coil has good resistance. Hoping it's just the distributor cap and rotor, but I need confirmation. How can I test the ESC Igniter (ignition control module) before I buy a new one? Is there anything else it could be?