I am looking to sell my Red '89 Conquest TSI (SHP) 140,195 miles   It was rear ended about 2 years ago and the tail lights, trim, and hatch need to be replaced. I am still in the process of finding the parts and may be replacing them myself. The unibody also needs to be pulled out so the new hatch will close properly. I also might be able to do this myself. The bumper should be repairable. It only sustained minimal damage and has 2 minor holes.   The car starts and runs great and has new inject

Hello i want to exchange my harness located on engine bay to the ecu for a harness in better conditions...so how I remove it?...or what r the steps to remove it...and they come out from driver side or passanger side?!...thank u for your reply

Ok, doesn't want to embed. Still good though!

I will say first that I don't have the gauge cluster or hood connected, and the ecu isn't connected, I'm pretty darn sure that I connected everything under the dash after I (just) did the heater core. I did unplug the control panel of the HVAC to the computer part behind it, then re-connect.   So will it work if the gauge cluster is unhooked, and might this just be a connection problem? there are no backlights and no side-lights in the display, but the buttons are lit.   Thanks in advance.