-
Images
- 4 replies
- 426 views
- Add Reply
- 13 replies
- 726 views
- Add Reply
- 11 replies
- 5126 views
- Add Reply
Not exactly new, but i have my first problem
By BrokenQuest,
Hi guys. I've had my quest for about a year now. Its not perfect but not a pile either. Right now i drive it daily and it does its job fine. Except for lately. When I first got the car, the oil pressure gauge read really oddly. It showed low at idle then normal (about 3/4 gauge) under load. Sometiems at idle it would sit about halfway. Its been this way for the last year and my oil levels were always fine so i never stressed. A few months later i would hear ticking from the engine arou
DELETE
tranmission strengthening pan
By 19cturbo,
A friend of mine made this for me. Quality, aluminum 3/4 inch transmission pan. Has grooves cut on the inside to help aid in draining all the fluid when you change it. This is similar to the TUFFpans but slightly thicker and i dont believe they have the grooves cut for draining. Has a small mark machined in the bottom to let you know which way is the front. I used a roll of gasket maker and made my own gasket, or you can simply use RTV. I will include the bolts to run this, youll need to reuse y
1998 Jeep Grand Cherokee 5.9 Limited - $3900
By strang3majik,
Hey guys, I have my 1998 Jeep Grand Cherokee 5.9 Litre Limited for sale. It has 93k miles. 5.9L V8 (one year only special edition option), automatic transmission, trac lock Spicer 44 rear axle and Dana 30 front axle. 3.73 ratio. ...I'll start out with the bad... Transfer case needs replaced. Drives great in 2wd, however. Dent in hood from a deer The A/C works and is ICE COLD! Since I've had it...I've replaced.... New 150amp Alt New water pump and 180* T-stat New shocks New tie rod end
