Sorry for the bad pics. These rods were race prepped by Tim Wilkerson's shop in Springfield Illinois. They were magnafluxed, balanced, beams ground and polished and sized to for .020 under crank.   They have new stock mitsubishi rod bolts, They are a little lighter and just as strong as the arp's i was told. They are for a stock style press pin.   I had two of these sets done at the same time in 2008. The other set I had bushed for a floating pin. Those still havent made it into my block yet

I just installed an aem uego wideband because my damn lc-1 wouldn't calibrate or read properly. I'm very impressed with the uego. The gauge that comes with it is nice and the unit is precalibrated. Very highly recommended!

Anyone use these or have any experience using them Seem like a great option instead of using t-clamps or worm gear clamps on our coolant hoses. The reviews are pretty good. I think even NAPA sells them. I hate using those small worm gear clamps on the 2 small water pump coolant lines.     http://www.mcmaster....-clamps/=mboshc     http://www.speedwaym...clamps&deptId=0

Picked up a MPI intake from hiko. Easy to deal with and shipped fast. I'd do business again with him.