in bringing "personal issues" into the threads & in front of the members. It should have stayed within the PM's as I had 1st intended. I see that the thread has been cleaned up from all but (1) reference of what transpired. Post # 55, can it also be removed, Thanx! Jerry

Looking to get the D2s on earlier than planned if my Cosmos & Tokicos sell. I'd like to install a good set of upgraded front & rear sway bars while it's all apart if the price is right. Do you have a pair lying around?

probably a few years off and of course just speculation at this point     anyone see this becoming a sqc engine swap candidate @ 300hp from the factory?

Selling my engine off. It's a g54b, it's not complete valve cover to oil pan, but everything is there except cam. Had not decided what can to run. The head is a complete marnel ported polished with 2 mm bigger stainless valves, double valve springs. I have to look again to see what the spring seat pressure was set at. The bottom end right now is a complete short block. Arp rod bolts, race prepped rods, .60 weisco pistons, deleted balance shaft, freshly hones and assembled. Everything was done p