Jump to content
  • Welcome (back) to StarQuestClub!

    OH NO!!!

    The data center where the site was housed on a Virtual Machine was shut down. The person who was in charge of the VM never saw the emails about migrating because it was flagged as spam and went to his junk folder. Long story short, they turned off the lights and locked the door without SQC being migrated to a new server.


    Unfortunately the most viable backup to use is from Nov. 2015 so we lost numerous posts and registered members. If you joined after that date you will need to register again.


    The new site requires you to use the email address in your profile to log into SQC and whatever password you had back in 2015. If you don’t remember your password there is a “Forgot your password?” option at the bottom of the Sign In block. If you don’t remember the email you used in your profile contact one of the Moderators for assistance or email loginhelp@starquestclub.com 

    BOV FAQ

    SQF
    By SQF,
    To answer the posters question, the section of the bov that attaches to the intake needs to be attached to a flange on the Upper intercooler pipe, or cold side of the intercooler(between the intercooler and throttle body) the vaccum line for the bov can be taken from any vaccum source on the intake manifold that contains both vaccum and positive manifold pressure.     As the intake manifold  becomes positively charged (boost) it pushes the diaphram of the bov valve closed holding the boost in

    WHEEL HOP

    EddieT
    By EddieT,
    This topic has been moved to [link=http://www.starquestclub.com/cgi-bin/starquest.pl?board=general;action=display;num=1019628450;start=0]Virtual Mechanic[/link] by BuzzKill.

    air intake system for quest

    Sean_P
    By Sean_P,
    Guys I've been playing with the idea of modifying the stock air can to get its air from a scoop in the passenger fender just above the wheel well. There is already a opening for the stock air supply in the engine bay. It would need to be enlarged for maybe a 3 or 4 inch inlet which would have to be fabricated to match up with the air can and the inside face of the fender, then possibly a louvered scoop could be made for the fender, like you see on some of the BMW’s. It would be almost a stra

    READ THIS BEFORE POSTING ON THE ENGINE MODS BOARD

    Boosted_One
    By Boosted_One,
     I have been moving a few posts from this engine mods board over to the virtual mechanic boards. The reason I moved these posts is because this section is mostly engine mods that people have done and post the install info or part numbers. pictures, etc.   So let's say a person wants to know about installing a 14G. This question would be better suited for the virtual mechanics area. Say another person posts info on how they put a carb on a Starion. This would fall into the engine mods board cr

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...