This radiator was running on my starion it is modified to run with the cooling system on our cars just might have to figure what hose you can use I believe it will work with stock hoses but not sure I'll have to find the hoses I used if I do they will come with it and it also has an aftermarket electric fan attached just message me at 3144432749 for pics and price is $100 plus shipping

All you need for MPI or TBI Total Engine Control (TEC). Came to me in a parts bundle, I've taken the time to clean it up, check all the wiring, power up the ECU, comm with the ECU, load the tuning software onto my laptop and desktop to ensure it still loads and label the harness. It's EVERYTHING you need including made for Starquest 60-2 trigger wheel on a Starquest crank pulley, made for Starquest crank trigger that mounts to the timing case, twin coil wasted spark ignition system, 3-bar GM M

This is an unknown brand intercooler with a knock off greddy blow off valve and piping and the mounting brackets Uses tbolt clamps instead of hose clamps this was running on an mpi swapped station with a holsett turbo all the plumbing is 3 inch I believe if not 3 inch its 2.5 inch and this IS NOT BOLT ON UNLESS YOU HAVE A HOLSETT HX35 TURBO AND IF YOU HAVE THE RIGHT MPI MANIFOLD BUT THIS CAN EASILY BE MODIFIED TO WORK ON A NON MPI CAR all you would need is a reducer coupler for the stock turbo a

Never going to use this setup, was going to use it on my Turbo Raider running MSII, but going with MPI. Came on a car I bought that PO couldn't diagnose after an engine rebuild, and I only putted around the neighborhood. Likely less than 10 miles on setup before I put the car back to bone stock. Delphi injectors scribed with "U44" and "O93" which I assume are lb, but I was told are factory replacements....I cannot confirm or deny that. If lb, that would indeed put them really close to stock