This sleeve is great for protecting the flexible water lines that some use to connect to the turbo. the braided steel lines actually do negative work and help transmit the heat directly to the rubber hose inside and reduce the life of the hose. in addition, they hide any deterioration to the hose as they become brittle due to the heat and break appart. this sleeve will greatly reduce the temperature that the hose is exposed to.   another great use of this would be for the folks doing MPI conver

This should probably be added to the FAQ since I couldn't seem to find any instructions on it:  ???   1.  Remove the 2 screws holding the hood latch in place and remove hood latch.  Pop off the A/Int Wip Cancel button and remove silver ring (big nut basically).  Pop cover from opposite side and remove screws from both.  Remove fuse panel cover.  Remove 5 screws from bottom of steering column plate.  Remove plate.   2.  You should see an abundance of connectors including a big blue one.

i cant find one anywhere!!!! what are you guys using and where did you get it? thanks.

could i use an intake off of a 1st gen eclipse for my car and could i just run the injectors in parallel w/ the other 2 injectors?   thanx   Jeremy