Been chasing this monkey since I did the MPI swap.   When I crack the throttle, I get a lean condition for a split second before the engine revs. The engine will stall a little from idle, before it revs. While moving, it's not as noticeable but you can see it on the uego. Other then this, my car runs on the rich side (11.9-14ish). I've adjusted the throttle pump map, it does not seem to help. Changing the throttle deadband value seems to make the problem worst.   Any suggestion as to where I sho

This is my newest toy that I purchased earlier this year. It is a 2001 Starcraft Starcaster 1754, with a Mercury 90/65 Jet motor. It has a 42lb. thrust 12V trolling motor. It has 1 livewell in the front and 1 in the rear. I have used it in a few bass tournaments this year. I can run in about 4 - 6" of water at full speed because of the jet drive. The boat will probably do about 32 mph. The previous owner, my fishing partner, hit a rock while going through a small channel and ended up with

i need two 16x8 fronts.. any condition.. i am in ohio.. if that even matters

Only the best for my car.... I don't know about you... but the "plumbers" tape wasn't cutting it for me.   This is actually for your CAR, self adheres to itself, water proof and has a temp rating over 250 deg. won't leave a slimy residue and pretty much turns to a "rubber" like feel once finished.   It's not super shiny ethier...   http://img383.imageshack.us/img383/6493/picture001fy3.jpg   http://img85.imageshack.us/img85/6831/picture004zh9.jpg     $10 bucks a roll!