I just installed my MPI and tried to start the car but I have no RPM on megasquirt. I have the VR sensor wired to the 2 dist wires white & blk on the harness side. When I crank it I get nothing but when I pull out the dist and spin by hand I can get a signal and the pump runs. Anyone try the HEI tip in the megamanual under wiring to amplify the signal. Could the signal be to weak at canking. I was also considering the caravan dist and upgrade to MSII but would like to get running for now. Ca

i got an 87 conquest running no converter and in order to pass this stupid e-check bull s*** i guess i gotta get one. ne one gotta spare?

what is a good brand of injectors to get? i got an 87 tsi with 77000 and a "few" mods here and there nothig to special just about 15-18 pounds of boost. the injectors i got were just to get it running decent enough to take her out this year. now i need better ones. if ne one has ne that they would like to part with or can recommend a good brand to get it would be much aprecciated

no one responded in the other section so im hoping that the electronic guros just dont go there. The other day I installed a Sunpro Air/Fuel Gauge on my 84. I hooked it up to the ACC line that also runs to my sterio (aftermarket) whichs runs strait from the fuse box (tapped the main line and soldered a NEW wire in place with a fuse.) I ran the wire over to the ECU and again soldered the wire for the O2 in place and used an ohm meter to make sure i got everything right. I found a line that was un