we have diamond plate1/8 or less   regular aluminum sheets 1/8 '' or less 3/16   1/4 plate bar stock 1/2 some 3/4''   if you need something small let me know l can get this stuff pretty cheep as long as it is shipping size   Lots of guys have been fabing new stuff and I'd like to help   so just let me know

Here is what I have. Prices are without shipping. I accept Paypal:   Turbonetics T4/T4 turbo. Unknown trim size. 2.5 inch inlet. orginally installed by EIP turbo in Maryland. 0 miles after rebuilt. 3000 total miles. Includes SS oil line. I guarantee not DOA for 1 week after receipt. I paid $700 plus $300 for the rebuild - $450 (SOLD)   1987 clutch cylinder. 3000 total miles. - $25   R-1 red/black racing seats. Red 4 point Matrix harness. Excellent condition. Custom brackets to fit conquest but t

I have an 1987 block. This is the block only. Never been bored. Cylinders have been oringed. Free if you pick it up. I'm in West Palm Beach. Email me if you're interested.   Thanks, Dennis   survyor2@adelphia.net

Ok. V3 boards, MS1 - MSNS-e 029 code. Stock dist locked down. 450cc injectors, 60mm tb, GM7pin HEI.   Ok, I have it idling and I can pop the throttle and not get a backfire or pop, sounds fine. I idle around 40kPa. If I rev past 4k, the stock tach jumps down to ~2k. but MS sees it fine. IF I run under 36deg btdc timing it just pops. on the other starion here. I took a timing light out there and see it idles at ~45deg timing and at 4500 its around 25deg. In the lowend it can goto like 20deg witho