PDodson Posted April 9, 2015 Report Share Posted April 9, 2015 I have to roll my windows down manually, how can I "jump" them out from the switch, u need to roll them down for when I go to paint my car, I have to remove my Window rubber Link to comment Share on other sites More sharing options...
scott87star Posted April 9, 2015 Report Share Posted April 9, 2015 Best of Show! Best of Show! So, at each switch the wires running to the motor are green/blue stripe and red/blue stripe, that would be at the connector that plugs into the switch. 12 volts to one and ground to the other makes it run one direction, reverse to run the other direction. 1 Link to comment Share on other sites More sharing options...
PDodson Posted April 9, 2015 Author Report Share Posted April 9, 2015 Thank you scott! I'll try it Link to comment Share on other sites More sharing options...
speedyquest Posted April 9, 2015 Report Share Posted April 9, 2015 Yep, I can second what Scotty said. Up until I made some custom switch setup for my windows I was manually opening and closing my windows with just a piece of wire lol. Link to comment Share on other sites More sharing options...
JohnnyWadd Posted April 9, 2015 Report Share Posted April 9, 2015 Best of Show! Best of Show! So, at each switch the wires running to the motor are green/blue stripe and red/blue stripe, that would be at the connector that plugs into the switch. 12 volts to one and ground to the other makes it run one direction, reverse to run the other direction. Nice. Better than using a power drill at the u-pull it. Having flashbacks now LOL Link to comment Share on other sites More sharing options...
JAinsworth Posted April 18, 2015 Report Share Posted April 18, 2015 Paul,Is your switch bad? I believe I have one that has been taken apart, cleaned, and reassembled. Hit me up if you need it.Jimmy Link to comment Share on other sites More sharing options...
Evoz17 Posted April 26, 2015 Report Share Posted April 26, 2015 Best of Show! Best of Show! So, at each switch the wires running to the motor are green/blue stripe and red/blue stripe, that would be at the connector that plugs into the switch. 12 volts to one and ground to the other makes it run one direction, reverse to run the other direction. Thank you Scott. I couldn't figure it out. I'm horrible with electrical. Link to comment Share on other sites More sharing options...
Recommended Posts