scott87star

My 87 has run a wideband O2 mounted in the factory spot for 30K plus miles without issue, still working fine. If you’re still running the factory ECU you can run the narrow band output from the wideband ( most have them) to the ECU.

Hey Nick, good to hear from you!

It can be the ABS system as well, that module is in the rear hatch.

Still have 3 in AZ.

Both sets sold.

I’ve got 3 but they’re sitting at my winter house in AZ.

Sold!

One set sold, one remaining.

Revolution (I think?) big brake kit, 300 mm diameter, I had them installed on my 87 MPI with factory front 7" wheels, ended up putting the stock setup back on with the intent to put these on my 85.5 which I just sold. Rotors are supposedly BMW units, they are very thick and heavy, included along with the brackets, wheel spacers, ss brake lines, all the nuts and bolts and clips and Wilwood four pot calipers. Very lightly used, street only. $500 shipped to the lower 48.

Sold!

I've got two sets of D2's NIB sitting in my garage, no longer needed. $1000 each shipped to the lower 48.

I did remote tuning for years through the msextra website, stopped when the Biden EPA started getting aggressive, the MS stuff is running everything including Toyota (especially the 12 cyl Japan only motor, I've done four) Nissan, many LS's, old Volkswagens, new Volkswagens, you name it and I've installed/tuned it. Also having been a DIY distributor they did a great service to us all with the MS3, MS3 mini and AMP'ed microsquirt. Motocam offers my design with an MS2 module on a motherboard with built in wide band O2, MAP and baro capable of fully sequential injection and ignition just for the Starquest with custom wire harness. Any of these solutions is a good one these days.

Pretty cool to see one unmolested in beautiful condition.

I’d check the throttle cable, if you don’t have a good block to chassis ground it’s known the throttle cable will fulfill that need and cause sticky operation eventually welding itself to the sheath.