Jump to content



tux

Member Since 08 Mar 2002
Offline Last Active Today, 08:45 AM
-----

Topics I've Started

Cruise Reed Switch

Yesterday, 11:16 AM

Posted Image

Does anyone know if it's terminal labeled 1 or terminal labeled 2 that is the output of the reed switch going to the cruise module?

WTT - 3" cerakoated downpipe with flex for 3" SS downpipe w/o flex

19 May 2020 - 04:47 PM

Anyone up for the trade.  I have a 3" Mookeeh downpipe with flex.  Had it cerakoated and installed in my 86.  Went to swap it into my mpi car and the flex pipe section gets in the way of my wastegate dump tube on Chad log header

So if anyone has a 3" Stainless steel downpipe they'ed like to trade for let me know !

Old cnm 20g1a

12 May 2020 - 09:05 PM

I lost my original paperwork.

I wouldn't suppose anyone has information on it?

Like compressor map, flow rate, and the like

Mitsubishi turbo round wastegate gasket

07 May 2020 - 06:07 PM

Anyone know a source for the round metal wastegate gasket it's for behind the plate under the downpipe hole.

I am fitting a mookeeh downpipe and this particular turbo didn't seem to have one behind it.

Trunk battery relocate

04 May 2020 - 04:43 PM

Hey all.  

I started putting battery in the trunk and ran 4/0 welding wire along the drivers side kick panel.

Where did you guys come through the firewall.  My arms are too thick to reach the grommet at the fender and really I just want to run this wire to the starter.  The starter wire goes to a block which meets the alternator and factory wiring.

I'd prefer to come through somewhere near the starter.

PO had some holes punched to the left of the steering column I attempted to use but the wire would run under the steering column and I don't think that would be too safe!

I was thinking behind the radio, but I don't want to remove the ducts there.

So any ideas where I can come out?!