This is a new one on me. These injectors were completely stuck in the housing... Didn't rotate or wobble, nothing.   I was thinking maybe someone JB welded them in, but after splitting the fuel rail the orings are loose.   Anybody ever seen injectors just refuse to come out of the housing? The car was impact that pushed the drivers front wheel sideways into the motor. Hard impact, enough that tunnel was notable deformed inside. Maybe the fuel rail was deformed? http://www.starquestclu

I took out a good portion of my interior the other day. No carpet on the floor. I noticed my passenger side floor drain plugs are completely rusted it. Should i keep the functionality of these and replace them with good ones, assuming one could even find them, or just cover up the holes and keep it moving?   I purchased this car already with an engine swap and i can see several holes about an inch long on the trans tunnel. I assume i should try to get this patched and not just cover th

So here's the story, you can check out my thread in the restoration section, but I've been tearing down stuff in the engine bay, and I'm at the point now where I have a head / block left... My question is it worth it to just pull the head off at this point?   Pros:   I can do valve seals, valve guides, and headgasket. I know the seals on 2 and probably 4 are gone based on spark plug conditions, I get a big white cloud on startup. I can inspect the cylinder walls. I will feel a lot better about 1

30 bucks shipped...can email pics...just need email address...............