Sold!

Getting ready to do this tomorrow but figured I would get some of the small stuff out of the way today. Took the top hat off one of the rear D2s and started installing the camber plate, but it doesnt seem to go on right. It seems to be off center and stops the top nut from turning after a certain point. I am using the lower sleeve and top not that came w/ the camber plate. Also, how to do you get it tight on there? I was able to get the D2 top hat off w/ an air gun but the MK1 plates are re

Looking for good running engine for 88 station.

what is the dimensions of the rear flange on the driveshaft?