OK,  WHO IS USING THIS SYSTEM ON A MPI SET-UP? I AM THINKING ABOUT GETTING ONE, BUT NEED SOME ADVICE..THE PUTTING TOGETHER PART IS A PIECE OF CAKE, BUT HOW USER FRIENDLY IS THE SOFTWARE TO GET THE CAR TO RUN PROPERLY..

Is there a difference performance wise between a bleed off type and a ball and spring type MBC? I have built a bleed off type from an air metering valve, it spiked really bad until I drilled a hole in the housing, now it wokrs perfect. I read that the ball and spring type is better. Does anyone have experience with both?

I just got back from a place  where they could make a ss oil feed line for $37.60 each so if anybody wants one I am in Louisiana.   My email is pauldodson1@cox.net

Can someone tell me what the first step(s) is in preparing my 89 for paint work?   I know you have to primer it but I was wondering what grit sand paper to use, materials, tools etc... Furthermore, how will I know if a particular section is ready for paint?  I have never done this so any insight would go a long way.  I am going to do this by hand in my garage...my goal is to prepare it completely, if possible, for paint work.   Thanks   TT