While doing a TPS reset and dropping a socket down below the intake manifold I found this connector just hanging out. It looks similar to the ground cable on the intake manifold, but that is plugged in on mine.   The connector's wire comes out of the loom right next to the wire that goes to the starter, they are the only two wires that come out of that thick part of the loom under the intake manifold   My car is an '87 manual trans car:

I need a good engine short block for my '86 Conquest. I would as consider a good complete motor. Anyone in NC, SC or VA help me out? Thanks, Colin

Question, are all the LSD rear ends interchangeable? Im looking to swap a lower mileage 1988 rear into a 1987 and wasnt sure if the center sections are the same considering the axels are 6 bolt verses 4 bolt.

So, I dropped the tank to do a Walbro install tonight, got it down and realized that all the phillips head bolts/screws that hold the pickup on are rusty as heck. I'd like to replace them, and It'll be easier if I can pick them up at work tomorrow and have them ready to go.   It looks like it should be a 4x10mm according to the parts locator... I'm assuming that's a a 4mm x 10mm. Can anyone that's replaced them chime in and tell me what they used?