i wanna say Thanx to Richie Rich for getting a great deal & personally handling this G/P project, & still seeing it through in making sure that all the guys that paid for the head is getting it, & also a very smooth transaction as well, dont forget prompt deliverey... many props to you my friend...                                                                                                                 drgns88quest

Well all, I figure it is now time to let everyone know what I've been doing to get the lifters preloaded enough to run the reduced base circle roller cams. I did the obvious. I have precurved, stainless steel washers inside the rockers, above the lifter. They oil fine, and so far the only issue was, I tried a washer that was a little too small in diameter first. It moved around on the top of the lifter, but did no damage. Now I have a larger dia washer in there, so it will not move around as e

The NSX has a nice low profile flip up light. Is their a way to modify lour linkage so that it only goes up about 3 inches, then install a slimmer light almost like our fog lights? Kind of like this.   Just a thought.   http://streetchallenge.com/uploadpix/up/Modified%20headlights.jpg http://streetchallenge.com/uploadpix/up/DSC03470.jpg

Anybody wanna try this route?   On U.S. GM cars made between 1986-1989 their ecms are programable using the kalmaker software and a lap top. The "808" #s are the last digits on the part number found on the ecm.   The ecms are cheap,  the eproms are removable and programable. Look for them in turboed 88 sunbirds and quad 4 equiped cars,  olds mobile calais, Beretta GTZ. Harnesses are cheap and/or you can get them at junk yards.   DFI conversions may be a problem but the ECMs have an inpu