Jump to content

    secondary injector

    G54Bstore
    By G54Bstore,
    need one to get the car going at a normal stockish rate before i start throwing upgrades at her let me know if you got a good green or blue secondary from a 87-89 car for sale please ty

    Oil line fitting size

    Doctor_Drift
    By Doctor_Drift,
    Yes this has been gone over the turbo is m12 by 1.25 which i do not need because im running a t3 turbo. The one in question is the outlet on the oil filter adapter what size is it? Possibly also m12 by 1.25? Anyways i have to make an oil line for the new setup. Please advise if you know the answer..

    died, will not start - after adjusting valves

    kenzie
    By kenzie,
    I adjusted valve lash according to the service manual, triple checked everything. Car started just fine and idled after that good. Took it for a test drive, 1/2 mile of neighborhood driving (not above 3k rpms) was just fine, got to an open road, took it up to higher rpms, drove ok, although felt at about 85% power, after the 3rd pull to 5k rpms it just cut off. would not start back up, so I just rolled it in a parking lot. Never would start back up. Let it cool down, still would not start.   Tow

    Turbos suited to a 300-400HP and TQ G54B application

    Aman
    By Aman,
    Title says it all. Working on learning about turbos, but it all seems like gibberish to me. Looking for a turbo that can hold it's own through the full RPM range and also not lag all the way to 4K RPM. Want to make 3-400 HP and Lb. Ft. of torque. Again, thanks for your time.

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...