whats the best way of running new speaker wire to the doors? all that left on my speaker install is to take the doors off and replace those speakers along with the wire for them. Jason

Here is a pic of my center console. I needed a way to cleanly house my gauge display and a couple of other things so I built this out of a sheet of CF.   http://snipurl.com/4xfe   I purchased the 11" x 8" x 0.032" sheet of CF from www.robotmarketplace.com. I was extremely impressed with the piece I got from them. It was shipped in a plain 8"x11" envelope via the USPS, but it arrived completely undamaged and unscratched. One side is a hard, clear epoxy and the other appears to have a very fine

Just wondering if anyone has had any luck getting the Grease/Grime/Oils off the front of the HVAC control so it looks clear again.   I've tried everything I can think of from Paint thinner, Plastic polishes, toothpaste, Comet, 0000 Steel wool (which seems to fog it up more than clean it) etc.   Anyone have any luck?   Joel

Does anyone have some before and after MPI conversion dyno numbers (running the same boost) using a Magna manifold on a stock or near stock engine? I don't care about other mods (big exhaust, etc) so long as they were the same on both runs (ie. the only change was Magna MPI, including aftermarket ECU I guess, and the plumbing to connect it up).