8)   I will post what I have up at the other place, and will be posting my progress as I finish.     -------------------------------------------------------------------------------- Well, I was bugged by that too, and my friend helping me, said it wouldnt be a problem cutting the firewall and transmission tunnel out, then moving the engine back a good 6 inches or so, which should give me a better weight distribution than I had before.   Tomorrow I plan on going to the parts store to find a new

I know i am going to get harped on about this, but a friend of mine is building an sr20de (t), and they motor is a pretty stout design. It has a girdle for and it is a DOHC engine run off a chain. There are just as much aftermarket parts for it as the 4G63.     What do you guys think of silvia sr20det, silvia trans, with custom driveshaft to conquest rear?

This was used to build my quest and it is a good platform i think for anyone wanting to start a v8 swap.   http://www.kabamus.com/garage/motorswap/invent.html

:roll: