Well peeps iv'e been quietly working on this for well over a year now and had a local Las vegas pipe bending/fab shop whip me up two prototype kits , kit one is a "half kit" copied and i have no shame admitting it off the T.E.P kit but much improved losing the dumb taper going into the factory intercooler piping , kit two is loosely based on the KAY D M full hardpipe kit which i have MUCH respect for after installing Kelly's kit not only in many of my own fleet of SQs over the past years but i

I need the connectors that connect to both thermo sensors(sensors at the bottom of the radiator). I don't need the thermo sensors. The connectors need to be in good condition with as much lead wire as you can give and have the locking tab in place.   Thanks,   Tom

Does any one know were i can get a aluminum radiator for my automatic conquest besides top end performance

trimmed a little of the coolant hose off on the throttle body side, it went up in the air and into my intake so what was going to be a 2 hour job turned into an 8-10 hour project. Removing the lower throttle body is a royal pain in the tail. I also found a vac hose that had nothing connected to it, the one the comes off the left side of the throttle body if you are at the drivers side wheel well. It is kind of hidden and faces the secondary air system. I think I hooked everything up right and it