I am under ther understanding I need to 'disable' the weights n my distributor to use my SDS 4e with ign and fuel control..   So how do I do it, I am close to finishing, and this is one of the last steps?

Just like the title says, I'm in need of a mechanical camshaft for my MPI setup.I have all of the stock intake components and a block, pistons, and rods that can all be put together without machining. Just needs a crank. Had 140 psi compression when pulled. I tore it down and realized that the bearings were spun and the timing chain was very stretched. I also have the stock front tan cloth seats from my car that are in good condition, they just need to be cleaned. Let me know what cam you have.

im lookin for a set of 83 taillights........hit me up

I just went with the 1g mass, and I would like to get a hard pipe+ couplers red if possible. I eliminated the air box, but there is that can that was on the air box that has a hose that goes to the oil pan can I get rid of that and how? If somebody can point me in the direction for the pipe, and a possible elimination kit for that can thanks!!!!!!