This vehicle is not mine! I just wanted to post it up for enjoyment and maybe someone over seas would like it.   http://www.trademe.co.nz/motors/used-cars/mitsubishi/auction-764626025.htm

PICS CAN BE SEEN ON CRAIGSLIST HERE: http://winstonsalem....4603413874.html DON'T HAVE PICS OF OIL PAN OR TURBO RIGHT NOW....   ALL PARTS FROM A 87. i have for sale a driveshaft, a radiator with fans and shroud, a oil pan, a BLOWN turbo (TURBO IS NO GOOD, can be rebuilt, fins are chipped and bearings are bad) and set of 4 je performance forged pistons(92mm). driveshaft has a little surface rust on the end, radiator does not have a cap, and pistons are good but rods are not, rods will come with

For sale is an SAFC 2. Unit is in good condition cosmetically, some scratches, screen has some swirl marks but display is clear and it doesn't cause and problems.   Unit comes with wiring, but not the direct plug in for the starion, so you will need to splice wires to get it to work, not too hard to do, took me about an hour when I had it on my civic.   I'm asking $125 Shipped USPS priority to the lower 48 states.   http://i264.photobucket.com/albums/ii183/Briman2021/safc1_zps305b9fdf.jpg http:

O.K. Just so it's clearer (hopefully) I need the small grommets, approx. 1/2" strong total, including both end lips. (length) It has a center section of approx. 3/16" strong. The center hole is approx. 5/16" diameter. If looking @ the 89' FSM: page 21-66 this part is not labeled as far as I could tell, however; it can be seen to the right of part #17, left side end of part #26,left of #21, etc. It pops into level arms/control shafts go through it. Probably not the best description I'm sure... bu