'78 Plymouth Arrow & '74 Dodge Coltknow what that is?
Posted 01 May 2019 - 12:57 PM
I got the other g52b all rebuilt. I used a caravan intake manifold i scored for like 60 bux on ebay, put the carb on that the car came with, and popped in a points style distributor. All top notch parts
After pulling out the engine, I figured now is a good time to replace the clutch, for insurance.
I had South Bend Clutch https://www.southbendclutch.com/ make me a new beefed up disk with a hub from an eclipse and a 8.5" friction surface. I went full face copper on the flywheel side and composite on the pressure plate side. The pressure plate was rebuilt to 1070lbs with a new friction surface.
After getting that all buttoned up, I slid the new motor in.
Also, I only had one working brake. So I replaced the master cylinder and fully bled the system out. There was some nasty stuff that came out of those lines. The rear reservoir of the master cylinder had like a muddy goo in it. I believe that was due to not having an o-ring on the cap. But, now shes got fully functioning brakes. Now I'm getting the wiring finished (the lights are being weird), I'm adding some relays, redoing some janky wiring, adding a switch panel and installing some gauges. I hope to go race at Gingerman on May 16th for tracknight in America.
Posted 20 May 2019 - 03:55 PM
And, a run on the wet track.
I wound up getting it on the dyno on Sunday
Posted 20 May 2019 - 05:29 PM
you had fun and that's all that matters!
B-71 87 TSI ~ RIP
Black 87 Starion ~ Mess SOLD!!!
Proud New 89 slightly Rusted Fiji Owner !!!
Posted 20 May 2019 - 10:02 PM
Zoom clutch, Fidanza flywheel, Stedebani shifter, KSport coilovers, ST swaybars, abs delete, a/c delete, cruise delete, JVE, BSEK, TEP steel brake lines, LSP braided cooler lines, CX Racing radiator, MK1 silicone hoses, MK1 pullies, *DM hard pipes & intercooler,14G turbo, ported exh. manifold, MAF Translator, 3.5" GM maf, Turbo XS RFL bov, *DM 3" exhaust, Cusco front strut bar, TEP rear strut bar, Enkei 92's, HKS turbo timer, AEM wideband, AEM boost gauge, AEM oil pressure gauge, SPA fuel regulator, Hallman boost controller
<SQ Garage> http://www.starquestgarage.com/
Posted 25 June 2019 - 10:41 AM
I have Hoosier tires on, dropped the front 1.75" and all new steering and shocks, and installed front camber plates.
I'm at 1/4" total toe out, and ~-2 degree front camber.
Also, I need to remake it because I just noticed I didn't register racerender, so it chopped my imported video.. doh!
Edited by button, 30 July 2019 - 02:33 PM.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users