Does anyone here know of a strut insert that would give the correct height similar to factory. I am using a recommended Toyota MR2 front insert and it’s way too short to use a factory coil spring. I am try to put off expensive coil overs.  Propose101 says you can use longer inserts but doesn’t tell you what works. See below for differences. Any help with this would be much appreciated, I have the car tore down currently. I was supposed to go to the NSRA Springfield event but this happened,

Hi everyone! I'm going to apologize in advance for the long winded introduction 😅. The year was 1996, I was 7 years old and a friend of mines dad had just got rid of his Nissan 200sx and replaced it with a Starion. He took us to get ice cream and I remember being captivated by the sound of the turbo whistling and just the way the car looked over all. As I grew with age I vowed to own one eventually. Problem is living in Canada I had never seen one on the road or for sale anywhere. Until June of

Looking ahead a little bit at tires for the Conquest and I'm curious what are the popular choices among this community. Can you answer with what you like and your reason for choosing that tire? Tire rack is pretty good for doing research and they have reviews by buyers but very few, if any, of those have a Conquest/Starion Thanks, Mark

Has anyone ever used these on their rear struts? I have the Mookeh housings with the MR 2 strut inserts and they are about 1.75 inches too short. The spacers would raise it about 2 inches. I’m just not sure if they would fit the top of the str