89 crank pulley...$60 shipped front license plate bracket....$25 + shipping AC compressor bracket...$15 + shipping   Crankshaft #1 needs light turning...$50+ shipping Crankshaft #2, 1 spun rod bearing, needs to be turned...$40 + shipping

By some miracle a pick and pull near me (2.5hrs away ) had not one but TWO conquests so I went today and pulled some stuff including both rear ends (an 89 and an 86). I've never had to do anything with my cars rear end and I have some questions.   1st question. About a week ago I found a set of 4.22s from a 89 Ram50 front end. I thought that was the correct size for the 86/87 starquest LSD rear... Is it? I haven't taken it apart enough to get an actual measurement, but just looking at

I need a front bumper for my conquest. its a widebody. the front bumper rotted out and I realized it was not salvagable . I pulled the bumper to install a huge fmic. I'm located in bristol ri 02809.

1987 Mitsubishi Starion ESiR $2800 in Huntsville, AL 256 513 6773   Cosmetically the body is pretty straight. The passenger rocker has a dent where a previous owner had jacked it up wrong. Same applies to the driver's side, only it's not on the rocker Clear is going on the roof, and clearcoat is gone on the hood. The front bumper had indentations from where it once had a front license plate. Minor spots where there is rust where the paint has chipped over the course of its life.   Good:   Has