Jump to content

    Factory Setup of Dash/Door Question

    CherryTSi
    By CherryTSi,
    Hi,  Question on the factory setup of the door/dash speakers.  I know they are wired in parallel and rated at 8 ohms.  But is there a cross-over between the dash and door speaker, if so where is it located.  Also where is the split off point from the head unit wire to the dash and door speakers.  I already put new speakers in the door and kept the dash, it works fine, but I know the dash sound not as good, so im considering ways of replacing them and keeping my current door speakers. Thanks,

    D hendrix "ChvyKc"

    scotty
    By scotty,
    I Purchased an ACT clutch from Dave from the Tristarion site . I was a bit apprehensive sending that much $ over the web (over 300) . No need to worry as this club member eased my mind and shipped the product quickly well packaged and sent e- mails updating the transaction shipping info Etc. I highly reccomend doing business with him as he's a No B.S.'r and took care of business ! Thanks again . Scotty

    Black83Starion

    stariongirl
    By stariongirl,
    nice deal Josh sent me both a tailight and a 1983 glove box lid. i agreed to buy both but only had enough to get the light...he sent both! s/g

    Flat Side non ic 2in OVCP

    Lizzord30
    By Lizzord30,
    Well got the new OVCP on and the 2 1/4in exhaust both helped a good deal. The exhaust helped with low end tq the most and intake pipe with higher mid range tq. The ovcp is the same for the mits turbo but this needs too be about 1 in longer. Now for the pics.   http://www.tristarion.com/forums/index.php..._mod&id=300   http://www.tristarion.com/forums/index.php..._mod&id=298

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...