I have an 87 Starion and need a new wiring harness, need the engine harness and would like to get the dash harness as well if the price is right. need one in good condition

anybody know what the size/thread pitch is of the hole in the throttle body where the plug is. i took the plug to home depot to get an adapter for my sending unit (1/8 NPT). the plug seemed to screw into a 1/4 fitting nicely so i bought a 1/4 to 1/8 adapter. well its not the right size because fuel shoots out of it when the pump primes even though i used teflon tape and high temp RTV. so anyone know the size? thanks.

I'm calling AEM tomorrow... but in the mean time I wanted to see if anyone on here might know what the problem is...   I installed an STS Turbo kit on my 07 Tacoma. The Turbo is remotely located and is just in front of the rear axle. The AEM instructions say to make sure to install the sensor 18-36" behind the turbo. I welded the bung about 20" behind the turbo, at greater than the minimum mounting angle requred as per the instructions. Every time I turn on my truck, the gauge reads 15 and

http://img254.imageshack.us/img254/2761/002id9.jpg   http://img120.imageshack.us/img120/4716/003tl8.jpg Bring it on!