SOLD   I have a harness i made for my megasquirt and MPI. I bought the 12ft wiring harness from DIYautotune.com and then bought all new connectors and sensors for my swap. Everything was soldered and i used the best heatshrink i could buy. The signal wires for the crank sensor is ran with shielded wire so there is no interference. Everything on this harness is done right. It has all the connectors for the sensors the megasquirt needs and is setup up to run EDIS4 ignition system. THIS IS PLUG AND

I ran this unit with my MPI and holset. Ran great, any work done on it was done by scott (scott87star). It is running the latest firmware as well.. 3.1.1   I had shipped this unit to scott to have it upgrades, he installed a larger map sensor (mapdaddy good to 44PSI), It is set up to run launch control, and has a circuit setup to log fuel pressure if you have an electric fuel pressure sending unit.   They list for $444.00 new on DIYautotune.com. The Map sensor alone list for for $65.00 on the si

hey     just wondering if u know where i could find a flange for the cylinder head to make my own intake.   thanks

As it says: Have a very Happy Birthday my friend! Look forward to see'n you @ PF13!