So my aem gauge is reading differently then megatune. I set the ms to what the aem instructions said per 14.7 air fuel, i was about to start adjusting the ms until megatune matched what the gauge showed but before i did that i wanted to ask here what settings people usd for the aem

After a long break from my Starion I have picked the project back up and am beginning to wire my MS harness up.   I have four sensors on my MPI intake and am not sure what plugs into them so that I can connect my MS to them.   1. coolant temp 2. coolant temp   (which one do I use?)   3. air temp 4. TPS   What plugs (connectors) go into these so I can solder them to the wires on my MS harness? I can't seem to find the correct for TPS connector for the TPS sensor.   http://i.imgur.com/akweSRi.jpg

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=120982946347 I gots me a pair comin!!

I've been given one of these pumps http://www.aemelectronics.com/high-flow-in-tank-fuel-pump-1290   I don't believe it'll work, but before I go pulling out the tank and making a mess of the garage I'd like to know if I can make it work... The reason I ask is it's an in tank pump.