I just installed the intake temp sensor into my intercooler and the temps are reading around 65 degrees. is this pretty normal?

I need these.Are they still availble from mitsu or somebody else?Has anybody made thier own replacements outta something.If so what was used. Mine are still intact enough to use as patterns for making new ones but didn't stop the water and moister as the car leaked while it sat waiting for me to get to it.A lot of the work I have done so far has been rust repair.Luckily nothing to bad;caught it before was too late.90% of what i have done over the last few months will never be seen but had to

Need a set of floor mats for my conquest...front and rear......   Is there a company that sells these brand new??

I finally finished redoing the fusible link box and alt upgrade. I pulled the #2 box and rewired all of it. From what I understand and have found out this is where a lot of problems start. I am happy with the way it turned out. I should have no problems for a long time. I have also added the GM junction block. %5BIMG%5Dhttp%3A//i118.photobucket.com/albums/o88/rf600/0204070910.jpg [/img]http://i118.photobucket.com/albums/o88/rf600/0204070909.jpg