Jump to content

    HOW TO: Rebuild/Repair your Rear Cargo Cover

    techboy
    By techboy,
    So this is a project 13 years in the waiting ... but I finally took to it this past week. At purchase, my car had a perfect rear cargo cover, which I was excited about b/c in all the other Quest sI had owned they were damaged.  It was short-lived, b/c one month later a tree fell on my car, crushing the roof, hatch, ... and busting up my rear cargo cover.  Well, that was 13 years ago already, so here's how I finally rebuilt it: Obviously remove the cover.  You can see where the branches

    ISO: '83 Hood Front Cowl

    bflann
    By bflann,
    I am in search of the front cowl for the '83 Hood, don't need the side vents, if not avail

    1987 conquest still lean

    Brian McGuire
    By Brian McGuire,
    1987 conquest runs a little butter since hook up maf translator white wire to rpm signal and went to rpm mode but say's needs good rpm signal where do i hook in to get best rpm signal.

    Rear Hatch Issues

    jeffball610
    By jeffball610,
    I've had issues with my rear hatch not opening with the lever by the driver's seat. It opens fine when I crawl into the back and move the locking mechanism. I don't believe my key works at all, as it doesn't seem to turn in the barrell. I've made sure there were no obstructions like the rear carpet. I have adjusted the action rods, and then back again because they didn't need adjusting. I adjusted the locking mechinism up and down as well. I even adjusted the hinges. The hinges are a pain t

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...