Going to a .060 over JE   What do you guys think of the compression ratio? I had 8:1's in and I I am leaning towards 7:1 now.   My head was milled twice and the block was decked once so far.   Thanks

Hi,   The damage is consistent with pre-ignition or detonation. It likely melted under boost. can't melt on decel as the engine makes no power and the fuel cut under vacuum cuts off all fuel- no fuel-no combustion-no heat, The air coming in actually cools everything down super quick.   Caused by too much boost, too lean, not high enough fuel octane, too much timing, plugs to hot on the heat range. If the fuel pressure holds under boost at high rpm and boost and duty cycle is less than 90%

Hello Fellow questers,   Can anyone give me directions as to where/how to get a new head shield that mounts underneath the hood?  Need a new one and don't know where to start looking.

Hello Fellow questers,   Who makes a good replacement leather shifter boot?  Can you give me a good link or number to a place that sells them?