Well all, I figure it is now time to let everyone know what I've been doing to get the lifters preloaded enough to run the reduced base circle roller cams. I did the obvious. I have precurved, stainless steel washers inside the rockers, above the lifter. They oil fine, and so far the only issue was, I tried a washer that was a little too small in diameter first. It moved around on the top of the lifter, but did no damage. Now I have a larger dia washer in there, so it will not move around as e

i wanna say Thanx to Richie Rich for getting a great deal & personally handling this G/P project, & still seeing it through in making sure that all the guys that paid for the head is getting it, & also a very smooth transaction as well, dont forget prompt deliverey... many props to you my friend...                                                                                                                 drgns88quest

CLick here (NESTARQUESTS.cjb.net)

The other day the hood release cable broke on my girlfriend's Conquest. After following some advice i found of this great site i got the hood open.  Around here i could not find a factory replacement hood cable so i went to my local Autozone and got a  Motormite universal hood release cable. It runs about 15 bucks here. It's a pretty compleate kit. But  to use it it needs to be modified. One end of the cable has a eyelet end  and the other has a long squared looking log.  Cut the squared log off