Jump to content

    Vacuum Advance Replacement Instructions

    BuzzKill
    By BuzzKill,
    Its a piece of cake. Should take less than 15 minutes to do:   1: Unclip the distributor pickup wire from the clip on the old vacuum advance 2: Disconnect vacuum line on the vacuum advance 3: Unscrew the 2 screws holding the vacuum advance to the distributor (they tend to fall and get lost easy - magnetic tipped screw driver recommended) 4: Unscrew and remove the distributor cap (leave spark plug wires attached) 5: Bend down the 2 triangle-shaped points securing the vacuum advance arm

    SDS Sample Maps

    Shawn_Silva
    By Shawn_Silva,
    Anyone running SDS have any timing and fuel maps they can supply?  Might be very helpful to myself and others on this GP coming up. Thanks!   Take care Shawn

    hydraulic to mechanical rocker conversion

    timdog
    By timdog,
    Does anyone know the specs and pitfalls to doing hydraulic to mechanical rocker conversion on a 1987 Quest? I've got the mechanical rockers already, but I don't know what the intake and exhaust back lash should be set at.  I left the stock 87 cam in it too.   Please provide some insight.   Thanks,   Tim

    Flat Body Section

    Lizzord30
    By Lizzord30,
    Have you thot of maybe making the Flat Body Mechanic to includ Turbo D50's, Mighty Max's, Montero's, and Raiders? Or maybe just say something about non IC'ed SQ. Tell me what you think.

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...