-
Images
- 3 replies
- 995 views
- Add Reply
- 4 replies
- 539 views
- Add Reply
- 4 replies
- 1079 views
- Add Reply
- 0 replies
- 550 views
- Add Reply
'88 Conquest restoration
By ckyskater733,
Hey guys whats goin on. There is a white 1988 chrysler conquest tsi in my grandfathers garage that is abandoned. It's not my grandfathers because he leases this house out to people, and someone just left it. Me, my stepdad, and my step brother are thinkin about fixing it up to make it run. We dont know when the last time it was used, so its obviously has s'ome bad gas in it. Also, there is no key to it, but the doors are unlocked, but were gonna have to change the locks and s***. It has le
fuel pump quest.
By supturbo,
I am about ready to start wiring my 88 for mpi conversion. I am using Chads intake and header with a t3/t4. I will using Megasquirt and the relay board. I have allready taken out the stock ecm since I will not need correct?? Also is there a place to hook up to the fuel pump somewhere besides running a new line? I see on the manual that their is a pump check wire under the hood, also pin 51, 57 on the ecm delivers power to the pump could I hook into one of those wires??
Thanks
JamesR
By vitamincj,
Picked up an auto tranny off of James for FREE! James was very responsive through posts and PM's. He even drove 45 minutes out of his way to meet me with the tranny. I would not hesitate to do business with James again.
CJ
dan87quest
By 3L_951,
A+
Paid for an expensive product in FIVE MINUTES!!!
Thanks Dan
