I have noticed that if I do not heat up the cam towers then the cam towers scrap the bolt holes in the rocker arm shafts. This leads to metal shavings in the rocker shaft. Twice now I had to reclean the tower and shaft because of this. To get around this issue I heated the cam towers up to 250 degrees in a toaster oven.   Anyone else have heat up the towers to put the rocker arm assembly back together?

86 only stuff   etacs 50 shipped map 35 shipped ignitor 35 shipped boost sensor 35 shipped       http://imageshack.com/a/img820/2130/mvu7.jpg http://imageshack.com/a/img843/5532/862ga.jpg

99% complete 86 manual seat belt swap in excellent condition. Comes with the following:   door panels upper and lower and the little top pieces too. complete seat belts with all hardware and plastic backing A+B pillars with tabs! and mounting hardware upper door trim with hardware perfect non sunroof headliner complete carpet with very very little wear mirror switch and coin holder! door sill trim     basically all you need is a 86 rear seat bottom and center console.   pics speak for themselves

I need a PASSENGER side front sway bar bracket.f Any other performance parts might be interested in as well. I could use a new power steering reservoir and all the rubber hole plugs that go in the rockers and in the rear wheel wells. Everything would be shipped to 68634. Thanks for any help!   Drake