Is there a way to modify the right side tie rods to make them easier to adjust? Its a pain to have to undo it, turn it in or out and put back up to get that side toe adjusted.   Has anyone either threaded in a stud with a sleeve to connect the two? Or cut off part of the RF inner and welded threads on?  

I got this as a whole deal with a head on ebay from a machine shop seller. (Ellis machine). I just need the head and was going to keep the whole thing but i could use the money. 2 pistons are scuffed on the skirt and other 2 pistons are perfectly fine. I would put new rings though. The rods are prepped and have new arp rod bolts. Block deck was machined flat everything was checked and tested by him. Crank is cut .010 under not sure the size of the pistons and bore of this block though. Waiting o

Got one thanks BuGG

what size or where can i get replacement quickly?