Hi all I have a complete rotation assemble with stock bore and compression JE piston Pauter forge rods and a knife edge crank, the crank oil feed has being improve to increase the oil feed for the main and rod bearing. The piston rings and rod bearings will be included. This rotation assemble has less than 8k miles on the setup the knife edging of the crank was 4.8lbs weight saving over the stock crank, to the best of my knowledge the main and rod journal is standard I can measure and provide th

Anybody just buy a white 87 Starion this November in Houston, TX? From an old lady in particular. Factory intercooled turbo with wide body, sunroof, and burgundy leather. I just want to know the plans for the car. I'm the grandson and was not able to take possession of the car until yesterday and I found out she sold it earlier this week. Any info would be appreciated.

Shout to itis1760....big thanks for the shipment. Thanks a bunch!

Selling my brake setup. I just pulled them off the car last night. This is the FULL BOLT ON setup. Polished PBR calipers, 4 sets of pads (all very usable) 2 sets of hawk blacks race pads ($200 each) 1 set of raybestos race pads ($200) and a set of stock street PBR's, with steel braided lines and all hardware! The calipers were just rebuilt 2 track days ago with brand new seals. (seals are easily replaceable and cost about $5 for both sides.) Brand new rotors have 2 track days on them. (le