Jump to content

    Exhaust fabrication.How many bends are needed.

    G54Bstore
    By G54Bstore,
    I'm in the process of ordering the pipe I need to fab up a 3 inch exhaust from my 3" dp back. Was wondering if anyone remembers roughly how many bends are needed . I imagine just a couple 45s? I'm doin some searches as well thanx.  

    Happy New Year to All

    Shelby
    By Shelby,
    I can't believe there's no thread already started any way here's wishing all of you guys and you family and friends have a very good year in 2015 , may all your problems go away and your health be perfect

    Can i take manual boost control off and just run line to w/g

    questtuner82
    By questtuner82,
    Ok so can i just run line from vac port on ovc pipe to wastegate? I have a manual boost controller thats junk and was wondering if the w/g will still work and only build factory boost levels with vac line direct to w/g from hardpipe to tbi

    Turbo Blanket

    IntercooledFlatty
    By IntercooledFlatty,
    do you run one on your starquest ? like em, don't like em ? and why   ... grabs popcorn

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...