Ok, so Im really bored and have an extra set of fogs complete w/bezel. I have wanted to remove the clear glass lense and orange plastic lense for a while so I just did it. I used the oven method with the door open, oven at 350, placced assembly on pine board. I couldnt believe how easy it was comparred to the tail lights....Took both the orange and clear apart in about ten minutes, no cracking. I wanted to see the inside and look at how easy it would be to replace the orange lense with a yellow

I'm having trouble trying to figure out some wire connections.  The ground is already done but I'm not sure on a few other wires.  Since I have no more coil, where do I hhok up the wires that connected to the coil??  Do I remove them completely?  The other wires, do those go directly to the starter?  I tried asking these in the VM but they weren't sure.  I was hoping someone who had done the battery relocation and was running an sds with coil packs.  Thanks guys....

Here are my newly installed gauge faces thanks to hcca, directions were very clear and installation was a breeze, hope you like.   Trini   http://www.we-todd-did-racing.com/wetoddim...zMXk1NDE%3D.jpg

The SDS TPS wire has a red, green, and black wire.  The new Ford pigtail has three white wires.  How do they go?  I know this has been answered too many times.