Jump to content

    Throttle body question

    Chio
    By Chio,
    I was wondering if the 2.6 turbo throttle body would mount onto the 2.6 non turbo intake manifold. 

    1987 Chrysler conquest tsi slight acceleration “boost leak”

    JakeTheErraticSnake
    By JakeTheErraticSnake,
    Having some issues where my starquest, almost acts as if there’s a boost leak if I slightly press on the gas pedal, if I bump it it’ll rev just fine. I know the idle is off as well. The timing has been set exactly where it should be. I’m also assuming my idle air control valve (the thing that’s 500$+ to buy) is going bad but that’s just idle. The car runs overly rich. I’ve cleaned out my injectors and can see them mist when I take off my OVP into my throttle body. Injectors were also taken out a

    Throttle body & mass air flow sensor

    Chio
    By Chio,
    Looking if anyone have a throttle body with the injector and maf sensor with housing for sell? Located in Sacramento CA 1984 Starrion

    Wow! This place is a ghost town these days!

    helrazr70
    By helrazr70,
    I have not been on here in a while since so many of us are on Facebook and it's just easier to communicate there. The drawback is that you can't categorize or archive information on Facebook so everything just fades to the bottom and vanishes unless you do a deep dive search--and that's if you remember which page/group what you are searching for was in. At least here it's organized and searchable. It sucks that all the SQC data was lost since 2015 but it is what it is I suppose. Based on my

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...